EAP Mode Configuration Mode Commands

 

 

The EAP Mode Configuration Mode is used to configure EAP authentication method supported by the system.

 

Important: The commands or keywords/variables that are available are dependent on platform type, product version, and installed license(s).

 

end

Exits the current mode and returns to the Exec Mode.

Product

All

Privilege

Security Administrator, Administrator

Syntax

end

Usage

Change the mode back to the Exec Mode.

 

exit

Exits the current mode and returns to the previous mode.

Product

All

Privilege

Security Administrator, Administrator

Syntax

exit

Usage

Returns to the previous mode.

 

method

Configures the EAP method used for authentication.

Product

PDIF, ASN GW

Privilege

Security Administrator, Administrator

Syntax

method { eap-aka | eap-gtc | eap-md5 } [ priority num ]

eap-aka | eap-gtc | eap-md5

eap-aka: Specifies that the EAP-AKA method is to be used for authentication.

eap-gtc: Specifies that the EAP-GTC method is to be used for authentication.

eap-md5: Specifies that the EAP-MD5 method is to be used for authentication.

priority num

Specifies a priority order for a specific EAP authentication method. num must be an integer fro 1 to 65535.

Usage

Use this command to specify the EAP authentication method(s) to use and to place multiple methods in priority order.

Example

The following command sets EAP-AKA as one of the EAP authentication methods and places it as priority of 3:

method eap-aka priority 3

 

 

Cisco Systems Inc.

Tel: 408-526-4000

Fax: 408-527-0883